
Quality control inside the machine
We have been building thermoforming machines and feeding systems for medical technology since 1986. The Vision Inspection System takes this a step further: high-resolution cameras capture every blister immediately after loading. Image processing software compares each image with the defined target values in real time.
Inspection covers, among other things:
- Presence and correct position of the product in the cavity
- Completeness and alignment of syringes, needles or accessories
- Foreign matter and contamination
- Quality of the seal seam and the print
Faulty packs are rejected automatically before they reach secondary packaging.
Your benefits
- Full cycle speed: Inspection keeps pace at up to 25 cycles per minute, including on our high-performance PERFORM-II.
- Complete traceability: Inspection results are stored and support your documentation under GMP and ISO 13485.
- Less waste, fewer complaints: Defects are detected early, and their causes can be addressed specifically.
- Cleanroom-ready: The system integrates into our machines made of stainless steel and anodised aluminium.
- Retrofittable: The system can be retrofitted to all our thermoforming machines.
Swiss precision from packaging to inspection
As an independent Swiss company, we develop the machine, the feeding system and the inspection technology from a single source. This means the Vision Inspection System is matched precisely to your product and your line.
Would you like to see the system in action? Request a demonstration and we will be glad to advise you on your application.